Vacuum Pipe & Fittings

For major remodeling or new construction this 80 foot of vacuum pipe bundle is a bit harder to use than our part #PI103. Very smooth inside, designed to reduce air flow resistance and help prevent clogs. This is the ONLY vacuum pipe we recommend for central vacuum systems. Not to be confused with Schedule 40 pipe which is 2 inch inside diameter and will not fit most central vacuum inlet valves. Does not include pipe couplings.

This 90 degree "L" is 2 inch outside diameter and used ONLY when attaching your inlet valve to the pipe. Any other 90 degree fittings you may need you should use part #PF102 only. This provides the best air flow for your system.

Our 90 degree sweep "L" is designed to be used with all 2 inch outside diameter pipe. Use in all areas where a subtle 90 degree is needed.

Use this fitting when installing a muffler on your vacuum system. One side fits 2 inch outside diameter pipe and the other directly into other fittings.

Connects branch lines to the trunk line. Be sure the airflow direction is correct.

Use 45 degree fittings as much as possible to smooth out the air flow.

Fits directly into other fittings and then into 2 inch outside diameter pipe.

Connects branch lines to the trunk line. Great for reducing the amount of turns and bends.

Use this fitting when subtle angles are needed.

Use this fitting when subtle angles are needed.

Use this fitting when subtle angles are needed. One side fits 2 inch outside diameter pipe and the other goes into any fitting.

For use in connecting three lines together.

Connects lines together to a trunk line.

For 2 x 3 wall applications when running additional line up or down.

Connects any 2 inch outside diameter pipe together for a sure fit.

Secure your vacuum pipe to avoid air vibration noise. Side clip should be used to secure your low voltage wire. Use one per 8 to 10 feet of pipe.

When coming out of garage walls or similar applications this covers the whole the pipe exits out of. Clean looking.

Caps off any 2 inch outside diameter pipe for later use.

Need to exhaust your system to the outside or other areas? Installs quickly and keeps dirt and unwanted debris from coming back into your exhaust system.

For use in new construction or remodeling. Place these over the inlet valve mounting plates. Protects the mounting plates from plasterers and painters. Then take them off and install the valve cover plate.

To be used when your wall is to thick and won't connect your pipe to your inlet valve. More than one can be used, the fit into each other well. Measures 1 5/8 inch long. Longer screws will be needed. Adds 3/4 inch more to your valve cover plate.